Electronics Projects Archive

The lamp used in the project is PCL805 tube. Older Readers may remember it because it was used in the vertical deflection pattern of most tube TVs. Today it can..

LM4952 It is not always necessary to have a high power audio amplifier. It is enough to power the small speakers with much less power. The presented amplifier meets this..

The L298 is an engine driver with two H-bridges. It can control two DC motors or one bipolar 4-wire stepper motor. Its main advantage is a large power supply voltage..

ATMEGA48 Many devices may be in standby mode during downtime. They do not perform any work, they are apparently disabled, but the control circuits are powered. To extract useful information..

Guitar Amplifier circuit the signal is directed to the tip of the TDA2050. The output power is 25 W with a load of 4 ? (17 W at 8 ?)…

The amplifier module is based on the TPA2005 chip with a bridged TPA2005 power amplifier capable of delivering up to 8V of almost 1.4W at 5V. Thanks to the small..

RF Remote ATtiny24 An uncomplicated radio system that enables remote switching of two power consumers whose power requirements do not exceed 250 VAC 5A The range of operation without additional..

USB programmer There are few components – the ATtiny45 microcontroller, two Zener diodes, a capacitor and several resistors. Of course, there are still connectors – USB plug and IDC-6 plug…

ATtiny25 Programmable Timer To describe the operation of the device, we will use an example – control of the electromagnetic bolt mounted in the wicket. In the simplest version we..

LiPo batteries are increasingly becoming a primary source of power, replacing other chemical sources of energy. The upgraded device, powered by a USB port or a mobile phone charger, allows..