Güç Kaynağı Test Devresi Elektronik Yük

| Mayıs 16, 2023 Tarihinde güncellendi
Güç Kaynağı Test Devresi Elektronik Yük

Özellikle güç elektroniğinde güç kaynaklarının testlerinde kullanılabilecek basit bir elektronik yük devresi sistem b761 op amp üzerine kurulu güç transistörünün emiterine bağlı olan 0.1 ohm direnç üzerinde güç harcanıyor ne kadar güç harcanacağı 1k trimpot ile ayarlanıyor

PCBway Türkiye PCB Manufacturer PCB Assembly

It is suitable for short-term and continuous exposure of DC sources such as power supplies or battery blocks and should not be missing if you have to build power supplies. On linear potentiometer, with an approximately linear scale can be calibrated, the electricity.

The power supplies are usually circuit to be tested by the power source, as long as it does more than 5 V provenance. (The B861 is still up to 3 V.) Resistors this capacity are curiously much more expensive than transistors, but you need a proper heat sink and can not change power sources burden.

Here it was easy to hole grid plate to set up a cold body, also was to T1 (isolated) attached.

The light-emitting diode D3 serves as the operating display as well as Z-diode.
There should be a red LED voltage because of smaller river, a green for better voltage stability, a reference element integrated B589 or TL431 is excellent spannungskonstant lights did not.


Kaynak: http://www-user.tu-chemnitz.de/%7Eheha/bastelecke/Konsumg%FCter-Bastelei/Netzteil-Tester/


Şifre-Pass: 320volt.com

Yayım tarihi: 2008/05/16 Etiketler: , , ,

Bir yanıt yazın

E-posta adresiniz yayınlanmayacak. Gerekli alanlar * ile işaretlenmişlerdir